27 Jun 2018

600 to 1200W power supplies have full MoPPs isolation

TDK Corporation has announced the introduction of the TDK-Lambda brand QS series of single output medical and industrial AC-DC power supplies.

Rated at 600 to 1200W output power, these high efficiency products utilise low speed fan cooling, significantly reducing acoustical noise. The QS series has been certified to both medical and industrial safety standards and are suitable for a wide range of applications, including BF rated medical equipment, test and measurement, broadcast, communications and renewable energy applications.

Operating from a wide range 90 to 264Vac input, the QS is available with three standard output voltages: 12V, 24V and 48V. The QS5 delivers 600W, the QS5H can deliver between 1080 to 1200W with an input voltage of 180Vac or greater and 700W below 180Vac. The QS7 is rated at 1200W over the full input voltage range. An optional standby/signal can be selected with a choice of one or two 5V standby voltages, unit inhibit or unit enable and a PMBus interface.

Overall case dimensions for the QS5 models are 127 x 63.3 x 270mm (W x H x D) and 176 x 63.3 x 270mm for the QS7. The QS5 has an optional IEC320 input connector, in place of a screw terminal block, for quick and easy connection. The units will operate in ambient temperatures of -20 to +70°C, derating the output power and output current by 2.5% per °C above 50°C. The QS series is covered by a seven-year warranty.

The units are certified to IEC/EN/UL/CSA 60601-1, ANSI/AAMI ES 60601‑1, IEC/EN 61010‑1, IEC/EN/UL/CSA 60950-1 with CE marking for the Low Voltage and RoHS2 Directives. With an input to output isolation of 4,000Vac (2 x MoPPs), 1.500Vac input to ground (1 x MoPP) and 1,500Vac (1 x MoPP) output to ground, the series can be used in BF rated medical equipment. The QS has a maximum earth leakage current of 300µA, while still complying with the EN61000-6-3:2007 and EN60601-1-2:2015 (curve B conducted and radiated) emission standards. The units also meet the EN60601-1-2 and EN61000-6-2 immunity standards.

Most popular news in Power management

Nanopower PMICs maximize battery and minimize board area
High drain and extended temperature models for lithium coin cell range
RS Components expands RS Pro offering with range of current transformers
TDK‑Lambda GENESYS+ series extended with 10kW and 15kW models
600-V GaN FET power stages supports applications up to 10 kW

All news in this channel | All news


Share this page


Want more like this? Register for our newsletter






Gladys West - Pioneer of GPS Sven Etzold | U-blox
Gladys West - Pioneer of GPS
GPS and GNSS positioning technology is such an integral part of our lives today that we rarely stop to think about where it all came from. When we do, we usually picture men in white shirts and dark glasses hunched over calculators and slide rules. In fact, one of the early pioneers behind GPS and GNSS technology was Gladys West - a black woman.









Radio-Electronics.com is operated and owned by Adrio Communications Ltd and edited by Ian Poole. All information is © Adrio Communications Ltd and may not be copied except for individual personal use. This includes copying material in whatever form into website pages. While every effort is made to ensure the accuracy of the information on Radio-Electronics.com, no liability is accepted for any consequences of using it. This site uses cookies. By using this site, these terms including the use of cookies are accepted. More explanation can be found in our Privacy Policy